This page is an unofficial LFoD record and is not legal advice. Verify the document against the official source before relying on it.
HB1462: relative to the height of a motor vehicle body and chassis.
Bill details
Version history, amendments, and roll-call votes were not present in the imported local bill data.
Sponsors
- Frank Byron House ยท Hills 20
Topics
Official links
HB 1462 - AS INTRODUCED
2016 SESSION
16-2494
03/01
HOUSE BILL 1462
AN ACT relative to the height of a motor vehicle body and chassis.
ANALYSIS
This bill eliminates the minimum height requiremenht for motor vehicle bumpers.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Explanation: Matter added to current law appears in bold italics.
Matter removed from current law appears [in brackets and struckthrough.]
Matter which is either (a) all new or (b) repealed and reenacted appears in regular type.
16-2494
03/01
STATE OF NEW HAMPSHIRE
In the Year of Our Lord Two Thousand Sixteen
AN ACT relative to the height of a motor vehicle body and chassis.
Be it Enacted by the Senate and House of Representatives in General Court convened:
1 Alteration of Bumper. Amend RSA 266:9 to read as follows:
266:9 Height of Motor Vehicle Body and Chassis. No person shall change the height of, or alter a bumper of, a private passenger vehicle so that the height of any horizontal bumper falls [below the minimum distance of 16 inches or] above the maximum distance of 20 inches. No person shall change the height of, or alter a bumper of, any vehicle other than a private passenger vehicle so that the height of any horizontal bumper falls [below the minimum distance of 16 inches or] above the maximum distance of 30 inches. Measurement shall be made from the level ground to the bottom of the bumper with tires inflated to manufacturer's maximum air pressure. If a vehicle is not commonly manufactured with a rear bumper, measurement shall be made to the bottom edge of the chassis frame siderails. No motor vehicle that has been changed or altered so as to exceed the limitations of this section shall be driven on any way without the prior approval of the director. For the purpose of this section, in addition to the definition contained in RSA 259:81, the term "private passenger vehicle'' shall mean a vehicle that has no provision for carrying a load other than a conventional trunk or the cargo area of a station wagon or similar type of vehicle.
2 Effective Date. This act shall take effect January 1, 2017.